HelpForCars.net- All Aobut Automotive Repairs
HelpForCars.net- All Aobut Automotive Repairs

P0141 FORD

P0141 FORD - O2 Heater Circuit Bank 1 Sensor 2

Comments |  Add Yours
Possible causes
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Help with this
Tech notes
The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it take the sensor to warm up and start sending an adequate signal. The code is triggered when the sensor is taking too long to warm up. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors. If the sensor and connector are OK, replacing the O2 Sensor 1 usually takes care of the problem
Help with this
When is the code detected?
During testing the oxygen sensor (HO2S) heaters are checked for open and short circuits and exessive current draw
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible higher than usual fuel Consumption
P0141 FORD Description
Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
http://engine-codes.com/uploads/images/2679.gif
FORD Technical Service Bulletins for P0141 code
2001 FORD RANGER ELECTRICAL SYSTEM:IGNITION:MODULE Details
2001 FORD MUSTANG UNKNOWN OR OTHER Details
2001 FORD MUSTANG 980000 UNKNOWN OR OTHER Details
2001 FORD MUSTANG 980000 UNKNOWN OR OTHER Details
1999 FORD MUSTANG UNKNOWN OR OTHER Details
2000 FORD MUSTANG UNKNOWN OR OTHER Details
1999 FORD MUSTANG UNKNOWN OR OTHER Details
2000 FORD MUSTANG UNKNOWN OR OTHER Details
1998 FORD CONTOUR UNKNOWN OR OTHER Details
1999 FORD CONTOUR UNKNOWN OR OTHER Details
Need more help?
Need parts?


HelpForCars.net OBD Codes Comments Powered by Disqus